CY8CKIT-064S0S2-4343W PSoC 64 Standard Secure – AWS Wi-Fi BT Pioneer Kit Guide, Doc. # 002-30680 Rev. *B
9
Introduction
1.2
Getting Started
This guide will help you get acquainted with the CY8CKIT-064S0S2-4343W PSoC 64 Standard
Secure – AWS Wi-Fi BT Pioneer Kit. Software support for this kit is exclusively in the FreeRTOS
ecosystem and will follow the flow specified by Amazon.
■
describes a high level overview of the FreeRTOS architecture, console and
development workflow.
■
Getting started with the Cypress CY8CKIT-064S0S2-4343W Kit
provides a step-by-step guide to
start working with the PSoC 64 Standard Secure – AWS Wi-Fi BT Pioneer Kit and run a MQTT
demo.
■
The
Kit Operation chapter on page 18
describes the major features of the PSoC 64 Standard
Secure – AWS Wi-Fi BT Pioneer Kit and functionalities such as programming, debugging, and
the USB-UART and USB-I
2
C bridges.
■
The
Provisioning Overview for PSoC 64 Standard Secure - AWS MCU’s chapter on page 27
describes the high level provisioning flow.
■
The
provides a detailed hardware description, methods to use the
onboard NOR flash, kit schematics, and the bill of materials (BOM).
1.3
Code Examples
A list of supported code examples can be found in the
section of the getting started
document under
Running other demos
.
1.4
Board Details
The PSoC 64 Standard Secure – AWS Wi-Fi BT Pioneer Board has the following features:
■ CY8CMOD-064S0S2-4343W carrier module that contains:
❐
PSoC 64 MCU (CYS0644ABZI-S2D44)
❐
Murata Type 1DX ultra-small 2.4-GHz WLAN and Bluetooth functionality module based on
CYW4343W
■
512-Mbit external Quad SPI NOR Flash that provides a fast, expandable memory for data and
code
■
4-Mbit Quad SPI ferroelectric random-access memory (F-RAM)
■
KitProg3 onboard SWD programmer/debugger with USB-UART and USB-I2C bridge functionality
■
CapSense touch sensing slider (5 elements) and two buttons. The slider and buttons are capable
of using self-capacitance (CSD) or mutual-capacitance (CSX) sensing methods.
■
A micro-B connector for USB device interface for PSoC 64 MCU
■
1.8 V, 2.5 V and 3.3 V operation of PSoC 64 MCU is supported
■
Two user LEDs, an RGB LED, two user buttons, and a reset button for PSoC 64 MCU
■
A potentiometer
■
One Mode selection button and one Status LED for KitProg3
■
A microSD Card holder