User Guide
12 of 32
002-29388 Rev. *B
2022-06-15
EZ-
PD™ BCR HPI Utility user guide
EZ-
PD™ BCR HPI Utility
2.
Power adapters power source capabilities
This part provides the information on Source PDO(s) of the power adapter. Click
Read Source PDOs
to
display the list of source PDOs. The following operations happen in the system:
−
Write ‘Read Source PDOs obtained from port partner’ message
(See PD_CONTROL in the BCR HPI
specification)
−
Receive ‘Read PDO data’ response
(See Response Codes in the BCR HPI specification)
−
Read Source PDOs from Data Memory (See Data Memory in the BCR HPI specification)
3.
BCR’s Sink PDOs Config
This part enables you to configure Sink PDOs. See
Demo: BCR sink PDOs configuration
2.5.2
Adapter-PPS
The Adapter-PPS tab enables you to request the PPS output voltage and current value to the PPS source. The
PPS feature is supported only by the BCR-PLUS device in the BCR family. Unless you are connected to a BCR-
PLUS device, Adapter-PPS is automatically disabled.
Click the
Read Source PDOs
to show Power Adapter Power Source capabilities. If the power adapter supports
PPS, PPS capabilities are automatically loaded in
PPS APDO List
.
for instructions.
Figure 15
Adapter-PPS tab