Hybrid DVR User Manual
TEC-VS-219-1905-V01
Scene
: Scene setting includes Indoor and Outdoor. Choose the scene to match with the place of the
installed camera.
Post Recording
: To set how long after an event occurs that the DVR will continue to record.
Latch Time
: To configure the external alarm time when the detection is triggered.
Alarm Out
: If the DVR supports to connect to external alarm device, it can bet set to emit an alarm
tone.
Show Message:
A letter “S” will be displayed on the screen when the PID function is triggered.
Send Email:
If an alarm is triggered, an Email will be sent to the preset email account.
Full Screen:
When the detection is triggered, the channel will be enlarged into full screen.
Record Channel:
Select the channel(s) to record when detection is triggered.
Area:
Click [
Setup
] to draw a virtual region in the camera picture.
Choose one of the Rule Number. It is the number of PID area. Maximum 4 areas can be set for PID
function.
To enable the detection in
Rule Switch
Choose a
Rule Type
.
A
B: DVR will only detect the action from side A to side B;
B
A: DVR will only detect the action from side B to side A;
A
B: DVR will detect the action from either side B to side A or side A to side B.
Use the mouse to click 4 points in the camera picture to draw a virtual region. The sharp of the region
should be a convex polygon. Concave polygon will be not able to save.
Click
Save
to save settings.
To modify the position or shape of region, click the red box in the region, the borders of the region will
be changed to red color. Press the left mouse button to move the position of the region, or drag the
corners to resize the region.
To remove one of the regions from the camera picture, click the red box in the region and then click
Remove
button. Click
Remove All
will delete all regions.
Note: The perimeter shall not be too close to the edges or corners of the camera picture, since it may
fail to trigger the detection when the target passes through the edges or corners.
The shape of the regions shall not be too narrow or small, since it may fail to trigger the detection
when the target passes through outside the perimeter.
