Hybrid DVR User Manual
TEC-VS-219-1905-V01
Record Channel:
To select the channel(s) to be recorded when detection is triggered.
Area:
Click [
Setup
] to draw a virtual line in the camera picture.
Choose one of the Rule Number. It is the number of LCD lines. Maximum of 4 lines can be drawn.
To enable the detection in
Rule Switch
Choose a
Rule Type
.
A
B: DVR will only detect the action from side A to side B;
B
A: DVR will only detect the action from side B to side A;
A
B: DVR will detect the action from either side B to side A or side A to side B.
Using the mouse click 2 points in the camera picture to draw a virtual line.
Click
Save
to save the settings.
To modify the position or length of the line, click the red box in the line, the color of the line will be
changed to red color. Press the left mouse button to move the line, or drag the terminals to modify the
length or position of the line.
To remove one of the lines from the camera picture, click the red box in the line and then click
Remove
button. Click
Remove All
will delete all lines.
Note:
1) The lines shall not be too close to the edges of the camera picture, to avoid any failure to trigger an
alarm when the target crosses through it.
2) The lines shall not be set too short, to avoid any failure to trigger an alarm when the target passes
outside it.