USER MANUAL — INFINEA TAB C
8
Programmable Options
Configure these optional settings via the SDK.
Charging Current
Charging current may be set to 500mA (default) or 1000mA.
Set Charging
The unit can charge the iOS device using its internal battery by enabling the “setCharging” setting. When the Infinea Tab C battery is below 20%, it begins
charging the iOS device battery.
Enable Scan Button
Select the Enable Scan button in the SDK.
Scan Mode
Supports the following scan modes:
Single Scan
Scanning a single barcode by pressing and releasing either Scan button.
Multi Scan
Scanning multiple barcodes by pressing and holding either Scan button.
Motion-Detect
Scanner is activated automatically when barcode is placed near the barcode engine.
Multi-Scan without Duplicates
Scanning multiple barcodes without duplicates.
Pass-Through Sync
When enabled and the USB cable is plugged in, the iOS device is synced with a Windows computer or an Apple MacOS.
When syncing is required, enable the Pass-Through Sync setting in the SDK. When this setting is disabled and the USB cable is plugged in, the unit only
charges, but does not scan.
To use the scanner again, the USB cable must be removed.
Idle Time
Default setting: 5400 seconds (90 minutes).