Replacing Battery
To replace the battery in the SCP-10 signature capture pad follow
the steps below.
Steps:
1.
Turn over the SCP-10 and place
it on a flat surface. Remove the
(2) screws as shown in the
figure on the right.
Figure 8
2.
Turn over the SCP-10 after the
screws have been removed. Lift
the upper-case as showed in the
figure on the right.
Figure 9
3.
Lift the touch screen to access
the battery. Reverse Steps 1-3
to install the new battery pack.
Figure 10
. . . . . . . . . . . . . . . . . . . .
Infinite Peripherals, Inc.
www.ipcprint.com
Page 18
SCP-10 User’s Manual v1.03