KIT
ENTRANCE PANEL INSTALLATION
ART. Z2101 – Z2102
Flush-mount installation
Z2101 / Z2102
Small flush-mount audio-video entrance panel for INFINITEPLAY video door entry systems.
2)
Secure the pick springs to the back box using the 2 nuts M3,
keeping them aligned plumb with the finish of the exterior wall.
1)
Install back box Art. Z9091 or Art. Z9091.C in vertical position at a
height of 165 cm from the floor to the top edge, as indicated in the
figure.
4
EN
3)
Place the product Small Entrance Panel within their back box by
pressing on the high and low part of it to facilitate the automatic
interlocking.
4)
To remove the Entrance Panel use the appropriate extraction key.
Before re-install the Entrance Panel, close the slot using the
appropriate stopper, positioning it from the back, as shown in
picture below.
Attention: without the stopper the Entrance Panel loses the IP54
class and could be subject to water and dust ingress!
