Infinition Inc. Rev. 02
10
4.3.5.1
Managing results in Review mode
First, make sure you are in the Review Mode as show above, then:
To navigate through the results, use the UP and DOWN arrows.
To make a new Series press the Series
button and confirm your choice by using the up/down
arrows and pressing Enter.
To delete a series press the Delete
button and confirm your choice by using the up/down arrows
and pressing Enter.
WARNING: this action is irreversible.
To access individual shots, first select your series with the arrows, then press Enter
To delete a Shot press the Delete
button and confirm your choice by using the up/down arrows
and pressing Enter.
WARNING: this action is irreversible.
4.3.6
Screensaver
If the display screen turns off, press any key, except power, to turn the display on.
4.3.7
Battery Installation
Install six (6) AA alkaline battery in the battery compartment. When not in use remove the batteries. To
conserve your batteries you should keep the Armed time setting at a minimum and the Screensaver time at a
minimum. It is advisable to have a spare set of batteries available.
* The unit can also be powered by a USB power supply through the USB port. 5V @ 1A is required.
4.3.8
Memory
The use of SDHC cards of known brandings is recommended. Regular SD card, SDXC and others may fail
to work in the device.
With the unit turned off insert a SD Card with sufficient memory to record the shots you anticipate taking.
Should you need to remove the SD Card always turn the power off prior to removing the SD Card. Make
sure the SD Card is clean and free of debris before inserting. Keep the SD slot cover in place to protect it
from dust, moisture, etc.
If no SD Card is inserted, the system will record the shots in its internal memory. As this memory space is
limited, you can only get advanced reports published on an SD card.
4.3.9
USB Port
Make sure the USB port is clean and free of debris. Keep the USB cover in place to protect it from dust,
moisture, etc.
4.3.10
Downloading Data
* You need an SD card in your device before you can download any data.
You can access the data by connecting a USB cable on the LabRadar and to a computer. The computer
should recognize the LabRadar as a Mass Storage Device and display the files available on the SD Card.
Alternatively, the user can turn OFF the LabRadar and remove the SD card to read it in a memory card
reader (Fastest).
The data needs to be recorded while the SD card was in the device to be accessible later by USB.
