Fig.6
Hook position for
Hook position for
Hook position for
H=30mm
top
H=40mm
top
H=20mm
top
N.B:
Use the hook contained in the "accessoires set"
f) In the event the cooktop is not installed above a built-in oven, a wood panel must be inserted as
insulation.This panel must be placed at least 20 mm from the bottom of the cooktop itself.
lmportant:
When installing the hob above a built-in oven,the oven should be placed on two wooden strips;
in the case of a joining cabinet surface, remember to leave a space of at least 45 x 560 mm at the back.
When installing on a built-in oven without forced ventilation,ensure that there are air inlets and outlets for
ventilating the interior of the cabinet adequately.
Gas connection for gas hob
The Cooker should be connected to the gas-supply by a corgi registered installer. During installation of this
product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience
of any subsequent removal or servicing. Connection of the appliance to the gas mains or liquid gas must be
carried out according to the prescribed regulation in force, and only after it is ascertained that it is adaptable
to the type of gas to be used. If not, follow the instructions indicated in the paragraph headed "Adaptation to
different gas types". In
the case of connection to liquid gas, by tank, use pressure regulators that conform to the regulation in force.
Important:
For safety, for the correct regulation of gas use and long life of the appliance, ensure that the
