NOTICE
The stainless steel grease pan and the cast-iron grill, located in the burner and grate packing box, must be
installed, respectively, below and above the electric heating element so that tile element is enclosed between
the two.
The product complies with COMMISSION REGULATION (EU) No 66/2014. In terms of the calculation
formula, please refers to the directive. The testing method is performed based on the directive EN 30-2-1
：
1998+A1
：
2003+A2:2005 (If it is regulated by the government, the relevant testing method would be done
accordingly). Please refer to the product label for the detail concerning the testing figures
In order to reduce the unnecessary waste and control the impact by the combustion, please save the energy
and adjust the gas consumption according to the necessity.
The specialized technician should avoid any damage and deformation of every component when he repair
s the product. The change of relevant components must be done by the authorized technician under the g
uidelines by the manufacturers and distributors. This is a necessary way to avoid the working efficiency im
pacted.
How To Use Your Appliance
The position of the corresponding gas burner or electric hot plate (if present) is indicated on each control
knob.
Gas Burners
The burners differ in size and power. Choose the most appropriate one for the diameter of the cookware
being used.
The burner can be regulated with the corresonding control knob by using one of tile following settings:
OFF
High
Low
To turn on one of the burners
, place a lighted match or lighter near the burner, press the knob all the
way in and turn in the counter-clockwise direction to the "High" setting.
On those models fitted with a safety device (F)
, the knob must be pressed in for about 6
seconds ,until the device that keeps the flame lighted warms up.
On those models fitted with an ignitor (D)
, the "E" ignition button, identified by the
symbol, must
first be pressed and then the corresponding knob pushed all the way in and turned in the counter-clockwise
direction to the "High"setting.
Some models are equipped with an ignition switch incorporated into the control knob. If this is the case, the
ignitor (
D
) is present, but not the "
E
" switch (the
symbol is located near each knob).
To light a burner, simply press the corresponding knob all the way in and, then, turn it in the counter-clockwise
direction to the High setting, keeping it pressed in until the burner lights.
Caution:
If the burner accidently goes out, turn off the gas with the control knob and try to light it again
