QTY
SIZE
COLOR
Style
QTY
Style
4
21'10"
Orange
Hip Rafter
1
8 Way Crown AT
2
16' 5"
Brown
Keder
4
Regular Corners
2
16'1"
Brown
Rafter
4
Regular T's
8
14'4"
Red
Spreader
8
Ratchets
8
7' 8"
Black
Legs
8
Baseplates
8
Weights / Stakes
40
Tent Pins
1
Brace Package
Pre-Site Inspection- Call your local utitlity companies prior to installation for any underground obstructions.
1. Layout the frame parts in the estimated location peertaining to the diagram. The spreader pipe is placed out to form
the perimeter, and the rafters are laid in the interior location.
2. Start with the 8 way crown. Lay the crown on a flat surface to determine the correct placement, when the crown is on
a flat surface the angles that are not touching the ground (every other one) will correlate with the 4 corners.
Attach the hip rafters (21' 10" orange) to the 8 way crown at the angles, that do not touch the ground, by sliding the pole in
or over the fitting and lining up the holes in the pole with those in the fitting. Place a pin in the first hole to secure the pole
in place. Repeat at all four corners.
3. Attach the poles (16' 1" brown) to two of the remaining angles of the 8 way crown using the same technique as in step 2.
Attach the two 16' 5" Keder Pipe to the remaining opposite angles aligning up the 8 way crown with the keder slots.
4. Connect the corner fitting to the hip rafter by sliding the pole in or over the fitting. Line up the hole of the pole with
those of the fitting and place a pin.
5. Join the Regular T fitting to the rafters by sliding the pole over the fitting. Line up the hole of the pole with those of
the fitting and place a pin.
6. The perimeter is ready for assembly. Connect the Regular T to the corners using the spreaders (14’4” red). Slide
the poles over the fittings, line up the holes, and pin the pole and fitting together. When all of the spreaders have been
secured in place, the frame will be complete.
7. Slide the keder on the tent through the keder pipe starting at the regular t going up through the 8 way crown, then
come back down the other side. Repeat the step for the other end of the tent top.
8. Secure the tent top to the frame by fastening the straps on the inside of the tent at each corner location.
9. Start at one corner and manually lift the frame so that the leg (7’8” black) can slide over the corner fitting.
Pin the leg to the fitting. ( When raising the tent, raise INTO the wind)
30 x 30 All Trac Frame Tent Instructions page 1 of 2
Corner
Optional Items
All Seasons Tent Sales
30 x 30 All Trac Frame Tent Set Up Instructions
Components
Pipe
Corner
8 Way Crown AT Regular T
16' 5" Keder
Pipe
16' 5" Keder
Pipe
