11
14
Screw
Installation Method
Step 1: Unpack the massage chair
Unpack the cartons, carefully taking out pads and cushions, accessories
box, and unit pieces.
Check all accessories with packing list.
PREPARATION BEFORE USING
Home page in Auto Mode
During use, press MENU twice to return to the home page immediately.
On the home page, under either Manual Mode or Auto Mode, press the
left and right button to adjust air pressure intensity. Under Manual
Mode, press up and down to adjust massage roller speed.
Press AUTO to choose Auto Program directly.
Please do not disassemble the massage chair for any reason.
Please do not spill water or other liquids on the controller in order to
avoid key malfunctions and error codes.
Please do not place heavy objects on the controller or power cord.
Home page in Manual Mode
NAME AND FUNCTION OF EACH COMPONENT
Caution
Caution
Note:
1. Under both Auto Mode and Manual Mode, the remote will return to home
page as shown below if it remains idle for 10 seconds.
EXTENSION
Air tap port
Air pipe plug
Armrest unit
First, connect the seat’s air tube plug to the armrest’s air tap port.
Hang the hook of the armrest unit to the connecting rod of the backrest,
and then connect the armrest to the side of seat frame. Push the armrest
down to secure it in place.
Fasten the armrest to the seat frame with one screw. Repeat steps above
for opposite armrest.
Step 2: Installation of Armrest Units
Seat frame
Rear hook
Connecting
rod
Rear connecting rod
Hook
