21
iFX-640
Product code: 41552
6.
Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is intended for professional use as a spot light moving head. It is suitable only for indoor
installation. This device is not suitable for households and for general lighting.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Attention
Power supply
Before connecting the device to the power supply, make sure that the current, voltage and frequency
match the input voltage, current and frequency specified on the information label on the device.
Control Modes
The iFX-640 can be operated with a DMX controller and as a stand-alone device.
The iFX-640 supports the following control modes:
Stand-alone:
Manual/Auto operation mode (auto programs)
Master/Slave:
Auto operation mode (auto programs)
DMX-512:
24, 53, 59, 86 channels
For more information about how to connect the devices, refer to 5. Setup on pages 18–20.
To run the built-in programs in auto operation mode without a DMX controller, activate Built-in menu. See
6.6.6. Built-in Programs on page 28 for more information.
To operate the device in a master/slave setup, adjust the settings in Edit Mode menu. See 6.6.2. DMX
Channel Mode on page 25 for more information.
To operate the device with a DMX controller:
01)
Set the DMX starting address of the device in the DMX Address submenu. See 5.3.5. DMX Addressing
on page 20 and 6.6.1. DMX Address on page 24.
02)
Select the DMX channel mode. See 6.6.2. DMX Channel Mode on page 25 for more information. See
6.7. DMX Channels on pages 31–44 for complete overview of all DMX channels.
