background image

UNPACKING THE MASSAGE CHAIR

1

For best results, please follow these instructions in order.

This chair must be removed from the shipping container before 

powering on. The wooden frame on the bottom of the container will 

impede chair movement. Try to have two people, one on either side, 

lift the chair straight up using the metal frame. Carefully remove the 

armrests from their box and lay them flat on the floor. Remove the 

legrest from its box by gripping the front and back sides and carefully 

sliding it out.

Installation is complete! Enjoy your 

Overture massage chair!

Two people grasp left 

and right seat metal 

frame, while another 

holds the back of the 

chair as it is tilted. 

Then remove the 

massage chair body 

from the box.

Summary of Contents for OVERTURE

Page 1: ...abrook NH 03874 603 910 5000 www infinitymassagechairs com Please contact Technical Support at 603 910 5000 with any questions or concerns or watch our helpful tutorials at www youtube com infinitymassagechairs Thanks for choosing Infinity Massage Chairs to help unlimit your wellness ...

Page 2: ...ple one on either side lift the chair straight up using the metal frame Carefully remove the armrests from their box and lay them flat on the floor Remove the legrest from its box by gripping the front and back sides and carefully sliding it out Installation is complete Enjoy your Overture massage chair Two people grasp left and right seat metal frame while another holds the back of the chair as i...

Page 3: ...ease lines up with the right side of the connectors so they lock in ATTACHING THE ARMRESTS 5 Next carefully insert the alignment nub on the arm with the corresponding socket on the chair body Bump it into place and make sure it is secure Now tighten the Phillips screw on the hole of the arm until tight Replace the rubber plug in place and repeat on the other armrest Finally zip the backrest into p...

Page 4: ...ully in place just enough so you can connect the air and power Connect the air hoses as shown Black to 1 and Gray to 2 Connect the power connector carefully making sure the thumb button is lined up correctly and clicks into place Remove the rubber plug from the hole shown below in the arm Under the plug is a captive Phillips screw for tightening on the arm Lower the arm onto the metal frame of the...

Reviews: