手控器使用方法
15
16
1
.
Press the on/off key to enter POWER ON status. Press Menu or other
buttons to select any auto or manual program. The massage chair will start the
body scanning process, and then begin the massage. Press the on/off key to
power off and put the chair back in the upright position. Remote control will turn
off in 3 to 5 seconds.
5
.
In the ON status, press this key to activate different auto modes. Six common auto
modes and six special auto modes are available for your choice: Recovery, Relief,
Stretch, Music Sync, Renew, Calming, Refresh, Energy, Revive, Active, Relax and
Healing. Relative screen display is shown on the controller.
12. In the ON status, press this key to put the chair in the zero-gravity position. Press
it again to enter sleep mode. Press it once more to return to the upright position.
OK
Air Intensity
Left
6
.
There are four direction buttons: Up, Down, Left and Right. In the Menu interface, it
is the navigator button: Press Up or Down to quickly browse the menu, and press
Left and Right to go to the previous or next menu. The Up and Down button can also
be used to adjust the massage roller position in the body-scanning mode. In the auto
and manual modes, the Left and Right button can be used to adjust 3D intensity.
OK
Hot Rocks
2
.
In the ON status, press this key to begin the HOT ROCKS program. The default time
is 5 minutes. Click this button again to will increase the duration by 5 minute
increments at a time, up to a maximum of 30 minutes. In HOT ROCKS mode, the
massage chair heat is turned on automatically at the highest heat setting.
3
.
In the ON status, press this key to adjust the air intensity either in auto mode or in
the air massage program.
3D
-
3D
+
3D
-
3D
+
Air
Intensity
Hot
Rocks
On
/
Off
Auto
Menu
Zero
Set function by pressing Menu key.
Speed
Width
Intensity
3D
：
20
min
Manual Control
Manual Control
Up
Down
Right
Leg Rest Up &
Backrest Down
On/Off
Auto
Confirm Button
Leg Rest Down
Zero Gravity
Menu
Manual Control
C
h
a
ir
O
p
e
ra
tio
n
C
h
a
ir
O
p
e
ra
tio
n
Leg Rest Up
Backrest up &
Leg Rest Down
3D-
3D+
On
/
Off
Hot
Rocks
Air
Intensity
Menu
Auto
Zero
8. Hold this button to raise the leg rest and release it to stop at the desired height.
The remote control screen will display “massage position adjusting...” at the bottom
of the screen when adjusting the position of the chair.
9. Hold this button to raise the backrest and lower the leg rest. Release it to stop at
the desired position. The remote control screen will display “massage position
adjusting...” at the bottom of the screen when adjusting the position of the chair.
10. Hold this button to lower the leg rest, and release it to stop at the desired position.
The remote control screen will display “massage position adjusting...” at the
bottom of the screen when adjusting the position of the chair.
4. Press this button in the Main interface to switch to the Menu interface, where you
can choose a different massage function. Press again while in the Menu interface
to return to the Main interface.
11. Hold this button to recline the backrest and lift the leg rest, then release to stop at
the desired position. The remote control screen will display “massage position
adjusting...” at the bottom of the screen when adjusting the position of the chair.
7. In the ON status under the Menu interface, press the OK button to confirm menu
choice and enter next menu.
