106 |
www.HandiQuilter.com
Hook LED Board (QM23022)
U
CAUTION
: Electronic components can be damaged by Electrostatic Discharge (ESD). Follow all ESD
precautions in the
Electrostatic Discharge (ESD)
section at the front of the manual while handling
the hook LED board.
To remove the hook LED board
1.
Use a #1 Phillips screwdriver to remove the
hook LED mounting screw.
2.
Carefully detach the cable from the hook
LED board, making sure to pull on the plastic
connector and not the wires.
To install the hook LED board
1.
Plug the hook LED cable into the connector on the hook LED board.
2.
Use a #1 Phillips screwdriver to mount the hook LED board with the connector facing the rear of the
machine as shown in the previous image.
Hook LED Cable (QM23017)
U
CAUTION
: Electronic components can be damaged by Electrostatic Discharge (ESD). Follow all ESD
precautions in the
Electrostatic Discharge (ESD)
section at the front of the manual while handling
the main control board.
To remove the hook LED cable
1.
Remove the right rear panel. (See T
o remove the left rear panel
in section 21,
Rear Plastic Panels
.)
2.
Disconnect the Hook LED cable from the Hook
LED board, making sure to pull on the plastic
connector and not the wires. It may be easier to
first remove the Hook LED board.