HQ Infinity Service Manual
| 107
3.
Unplug the other end of the hook LED cable from the main control board.
4. Use a #1 Phillips screwdriver to remove the hook LED cable from the P-clip.
NOTE
: For ease of installation, tie a string or wire to the end of the cable to act as a guide wire to
use when installing a new cable before pulling the cable through the machine.
5.
Gently pull the hook LED cable up through the slot at the right rear of the machine, just below the
main control board. You may have to guide the front end of the cable into the cable trough so the
connector doesn’t get caught.
To install the hook LED cable
NOTE
: If you have used a guide wire or string, simply pull the cable through using the guide wire.
Make sure the cable stays in the trough in the lower arm. Otherwise, follow the steps below.
1.
Thread one end of the hook LED cable through
the right-side trough under the Infinity, just
behind the hook.
2.
Push it back toward the main control board
until you can see the cable through the slot
below the motor.
3.
Use needle nose pliers or tweezers if necessary to grab the hook LED cable and pull it up through the
slot.
4. Plug the front end of the cable into the hook LED board (and re-attach the hook LED board if it was
removed).
Guide the cable into this channel