122 |
www.HandiQuilter.com
5.
Rotate the encoder disc, making sure it stays centered
between the forked sensor, just until the Test 1 LED on
the main control board (left-most LED in the bank of
4 LEDs) turns green.
6.
Tighten the set screw at the top of the encoder disc
collar with a 2mm hex tool.
7. Rotate the hand wheel until you can access the second
set screw and tighten that one also.
8.
Turn off the machine power, wait for the LEDs to all go
off, and turn it back on again. This forces the processor
to re-set the Needle Up/Down positions that have
been stored in memory.
9.
Temporarily put on the left rear panel using one 16mm screw. This will help to keep the cables from
rubbing on the belt.
10.
Test the stopping position of the needle by pressing
the Needle Up/Down button on either handlebar.
When the needle stops in the Up position, the take-up
lever should be in its highest position with the needle
started on its way down.
11.
If necessary, remove the left rear panel and adjust the position again.