128 |
www.HandiQuilter.com
5.
Use a 2.5mm hex tool to tighten the main shaft
encoder down into the proper position. (See
To
adjust the main shaft encoder disc
earlier in this
section for proper positioning.)
6.
Remove the guide wire/string from the sensor cable
and plug the sensor cable into the J42 connector on
the main control board.
7. Align the rear bulkhead bolts and use a 5mm hex
tool to loosely install the six bulkhead bolts to
mount the rear bulkhead to the machine. After
all six are loosely installed, tighten each one in an
alternating pattern.
8.
Install the two idler pulleys with spacers as shown
using the 5mm hex tool.