132 |
www.HandiQuilter.com
7. Use a 0.05" hex tool to loosen the set screw on
the optical disc collar.
8.
Carefully pull the optical disc off the axle.
9.
The rear housing piece can be replaced if
desired, but is not likely to be necessary.
Remove the two Phillips screws shown to
remove the rear housing.
To assemble the Y-encoder
1.
Replace the rear housing piece if it was
removed using the two Phillips screws shown in
the last step of the removal process.
2.
Place the optical disc on the shaft with the bulk of the collar facing away from the encoder assembly.
Hold together while
tightening the disc collar.