26 |
www.HandiQuilter.com
Â
IMPORTANT
: When the thread cutter wiring
is run, it should be semi-taught in order to
keep it from being caught in the hook. The
wire should be tucked back into the upper
left channel of the hook frame extrusion if
pulled out during work on the thread cutter
or when the needle plate is removed.
U
CAUTION
: Care should be taken when the
needle plate is removed to not pull the
wires out or wrap them so they are closer to
the hook. Warn users!
Thread Cutter Connections
There are two connections from one wire sheath
at the front for the thread cutter and one connector
at the back which connects to J21 on the main
control board.