HQ Infinity Service Manual
| 89
3.
Carefully pull the power supply out away from
the machine frame to access the wire mounting
screws.
4. Pry the plastic protective cover off the top and
bottom terminals.
5.
Use a Phillips screwdriver to remove the wires
from the terminals on both ends of the power
supply.
6.
Carefully pull the remote power switch cable
from the connector near the green LED. Pull on
the plastic housing and not on the wires.
To install the power supply
1.
Use a Phillips screwdriver to connect the brown,
blue, and two green/yellow AC wires to the
bottom terminals of the power supply. Green/
yellow goes closest to the outside edge, blue in
the middle, and brown closest to the fan.
2.
Snap the plastic terminal protector over the
plastic terminal dividers.