InfiRay Outdoor
•
Tube TH35/TH50
•
Operating Manual www.infirayoutdoor.com
All rights reserved and shall not be copied and distributed in any form without written permission
⚫
Aim the reticle center at the target and shoot, and then observe the
position of the actual point of impact.
⚫
If the impact point is not the same as the aim point, keep the aiming
position still, and press and hold the
Palette (6) + Camera
(3)
buttons at the same time to freeze the picture, and the freezing icon
appears on the bottom center of the screen.
⚫
Rotate the rotary encoder
(7)
to move the reticle position, until the
reticle center aims at the position of the point of impact. For details, refer to section
Zeroing
.
Setting the Zeroing
Distance
If the default zeroing distance is not consistent with the preset target distance, you can set the distance
here.
⚫
Select a
non-primary distance
and enter the submenu for operation with a brief press of the encoder
(7)
.
⚫
Rotate the rotary encoder
(7)
to select the option "
Setting the
Zeroing Distance
".
⚫
Press the rotary encoder
(7)
to activate the zeroing distance reset
function, and then two small triangle symbols are displayed above
and below the number .
⚫
Rotate the rotary encoder
(7)
to set the number value of the current position from 0 to 9.
⚫
Press the rotary encoder
(7)
to switch among the positions of hundred, ten and one digits.
