4B
MFD ASSEMBLY INSTRUCTIONS
PLACARDS AND LABELS
T.
Remove backing from foam tape on Instruction Placard. Attach Instruction
Placards to Loop Upright aligning outside edge of placard to top and outside
edge of Loop Upright.
U.
Attach Weight Labels in recess provided on front of Weight Plates. All the
recesses should be aligned and to the right as you face the weight stack.
SHROUD HOLES AND SHROUD OPTION
V.
If no Optional Shroud Kit was purchased install plastic caps in all 24 shroud
holes. If installing Shrouds fasten to Loop Upright using 12 – 3/8 x 2 ½” bolts,
20 – 3/8” flat washers and 8 – 3/8” nuts (hardware found in Shroud box). The
lower two bolts on each side of the Front Shroud fasten into threaded
fasteners pre-installed into the Front Shroud.
10
