2
USB Cast
Plug dongle into your computer, and wait for around 12s (indicator is flashing) during boot up.
You are able to press the button to cast source when indicator is keeping on.
If the computer works with dongle for the first time, you have to run USBDisplay driver when it
pops up after plugging in dongle, or follow My Computer->CD Drive USBDisplay to run the driver.
Note:
1)
For win 10 system, windows defender should be disabled.
2)
In some cases, due to the blocks from anti-virus software, users may need to run USBDisplay
driver though computer was not used for the first time.
When communication established between dongle and receiver, a green button will appear at
left top corner. The figure reflects number of connected dongles. Click the button to manage
withdraw or cast of connected dongles.
