5
Run
“
USBDisplay
”
app, and scan the QR code. Your device will connect to iShare receiver hotspot
automatically.
Or connect the same WiFi with the iShare receiver, and select the IP address. That will generate
floating window permission, please confirm in your settings. Tap
“Start now” to enjoy your
mirroring.
Note: Only available on system older than Android 5.0
When starting to cast, your device will receive Bluetooth authentication notice. Please accept
application to enable audio cast. Otherwise, audio will be disabled.
If the application is denied by maloperation, you can enter into Bluetooth setting page and pair
iShare receiver manually. For the following-by operations, Bluetooth will be paired or
disconnected automatically when starting or quitting a cast.
Every time when starting a cast, you will get a notice that audio device connected. This indicates
that audio is ready to cast. Or you have to pair Bluetooth manually if there is no such notice.
2. Miracast
Long press any of right bottom icons at homepage to call out control center and select <Miracast
Receiver>.
