Page 14
Connecting AC power
1)
Connect one end of the AC power cord to the AC In jack on the back of the monitor.
2)
Connect the other end of the AC power cord to an AC outlet.
3)
Press the power switch. (The LED on the front of the monitor turns on.)
NOTES:
•
Your monitor should only be operated from the power source indicated on the label.
•
Always unplug the AC power cord from the power outlet when you are not using your monitor for an extended period
of time.
External PC touchscreen control setup
1)
Connect an external computer to the monitor using a DVI, HDMI, or VGA cable.
2)
Connect the Type A to Type B USB cable to the USB Type A jack on the computer and to the USB Type B jack on
the side of the monitor.
3)
The computer can now be controlled by using touchscreen gestures on the monitor.
TURNING THE MONITOR ON/OFF
1)
Verify that the power cord is connected to a power outlet and that the power switch is
ON
.
2)
Press the
Power
button on the remote or the right side of the monitor.
NOTES:
•
If the monitor does not respond to normal power down procedures, press and hold the PC box
Power
button
(located on the back of the monitor) for 7-8 seconds.
•
By default, the monitor goes into system standby after 20 minutes of inactivity. To change this behavior, use the
Daytime Power Management
feature within the Mondopad software or make power option changes within the
Windows Control panel.
Summary of Contents for BIGTOUCH INF5711
