38
M
a
i
n
t
e
n
a
n
c
e
&
T
r
o
u
b
l
e
s
h
o
o
t
i
n
g
5
Install the new lamp module.
6
Tighten the screws on the outside of the module.
WARNING:
Do not drop the
lamp module or touch the glass
bulb! The glass may shatter and
cause injury.
7
Replace the lamp door and the screw.
8
Plug in the power cord and press the
power
button to turn the
projector back on.
9
To reset the lamp replacement monitor timer, press the
menu
button, select the Setting menu, then navigate to the Lamp
Age option. Press the
select
button, and the message “Lamp
replace monitor reset” appears. Select Yes to reset the timer.
See “Using the On-Screen Menus” on page 17 for details
menu navigation.
Replacing the Batteries in the Remote Control
The life of the batteries depends on how often and how long you
use the remote. Symptoms of low battery charge include erratic
responses when using the remote and a reduced range of opera-
tion.
Follow these steps to replace the batteries:
1
Turn the remote face down in your hand.
2
Slide the battery cover off the end of the remote.
3
Remove the old batteries and dispose of them in an environ-
mentally proper manner.
4
Install two new AA alkaline batteries. Make sure you install
each in the correct direction.
5
Slide the battery cover back on the remote.
