2
1) INSPECTION
Inspect the UPS upon receipt. Notify the carrier and dealer if there is
damage. The package is recyclable; save it for reuse or dispose of it
properly.
2) PLACEMENT
3) LOAD CONNECTION
First, connect the UPS with Utility, then plug the loads into the outlets
on the rear of the UPS. To use the UPS as a master “On/Off” switch,
make sure that all of the loads are switch “On”.
These UPS outlets provide battery power and surge protection to the
equipment when utility voltage is outside acceptable limits.
Caution:
Do not connect a laser printer to the outlets.
3
4) CONNECTION OF TELEPHONE/NETWORK SURGE
PROTECTION
Connect a 10 base-T / 100 base-T network cable into the RJ-45
network surge protection “IN” jack on the rear panel of the UPS.
Connect from the “OUT” jack with network cabling to network
equipment.
5) CONNECTION OF COMPUTER INTERFACE PORT
Connect the supplied interface cable (RS-232 ) to the interface port on
the rear of the UPS through the computer interface port. See software
installation guide in the CD-ROM (Optional) for installation purpose.
