INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line
– Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 08 11 AA 59 203 12
5
7 . I N S T A L L A T I O N A N D O P E R A T I O N
1. Checking
When you receive your equipment, open the packaging and check that your AVR has not
been damaged. Packaging includes:
R1 600/1200/2000 VA
: AVR unit and a user guide.
2. Placement & storage conditions
The AVR has been designed to operate in a protected environment, at temperatures
between 0°C and 40°C and at a humidity level ranging between 0% and 90% (no
condensation).
Do not obstruct the ventilation slots. Install the unit in an environment which is free from
dust, chemical vapours and conductors. Moreover, in order to avoid any interference, keep
the AVR at least 20cm away from the CPU (central processing unit).
3.
Connection
Check the identification plate to make sure that the power supply is compatible with network
voltage and that the device is powerful enough. Plug the AVR into a 2-pole, earthed outlet .
Then, connect devices to the AVR.
4. On/Off
To turn the AVR unit on, press the power switch. To make sure the AVR is ON, check if the
green led is lightning. If the red led is on, it means that the AVR is regulation the voltage. To
turn it off, press the power switch again.
5. Connect Modem/Phone/Network for surge protection
Connect a single modem/phone line to a surge protected “IN” outlet on the back panel of the
UPS unit. Connect the “OUT” outlet to the computer with another phone line cable.
Caution
: The telephone line lightning arrester could be rendered inoperable if improperly
installed. This surge protection device is for indoor use only. Never install telephone wiring
during a lightning storm.
8 . T R O U B L E S H O O T I N G
Should the AVR fail to function correctly we recommend you perform the following tests
before calling the Hot Line.
Check list:
Is the main switch in the “ON” position?
Is the AVR plugged into the mains power supply?
Does the power supply fall within specified unit values?
Is the AVR overloaded?
