INFOSEC UPS SYSTEM X3 EX LCD USB User Manual Download

Page: 8 / 114

INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com

Hot Line

– Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 11 18 AA 59 205 10

7 . I N S T A L L A T I O N A N D O P E R A T I O N

1. Checking

When you receive your equipment, open the packaging and check that your UPS has not
been damaged. Packaging includes:

X3 EX 500/650/800/1000

: UPS unit and a user guide.

X3 EX 1200

: UPS unit and a user guide.

X3 EX 1600/2000

: UPS unit and a user guide.

X3 EX 3000

: UPS unit, a user guide, input cable.

2. Charging the batteries

This  unit  is  shipped  from  the  factory  with  its  internal  battery  fully  charged,  however,  some
charge may be lost during shipping and the battery should be recharged prior to use. Plug
the  unit  into  an  appropriate  power  supply  and  allow  the  UPS  to  charge  fully  by  leaving  it
plugged-in, with no load, for at least 8 hours.
The  UPS  will  automatically  recharge  its  own  batteries  whenever  the

switch is in the “ON”

position. You may use the UPS immediately, however the back-up power capacity may be
lower than the nominal value required.

3. Placement & storage conditions

The  UPS  has  been  designed  to  operate  in  a  protected  environment,  at  temperatures
between  0°C  and  40°C  and  at  a  humidity  level  ranging  between  0%  and  90%  (no
condensation).
Do  not  obstruct  the  ventilation  slots.  Install  the  unit  in  an  environment  which  is  free  from
dust, chemical vapours and conductors. Moreover, in order to avoid any interference, keep
the UPS at least 20cm away from the CPU (central processing unit).

Connection

Check the identification plate at the back of the UPS to make sure that the power supply is
compatible with network voltage and that the device is powerful enough to protect the given
load. Plug the power cable of the UPS into a 2-pole, earthed outlet. Then, connect
computer-related devices to the back of the UPS.

5. On/Off

To turn the UPS unit on, lightly press the power switch. To turn it off, press the power switch
again. Make sure that the power switch is kept in the “ON” position, otherwise the UPS will
be disabled and your equipment unprotected in the event of power failure.

Note

For maintenance purposes, please turn the UPS on before the PC and other loads,

and turn it off after the connected loads are turned off.

6. DC Start

X3 EX units are equipped with an integrated DC start function. To start the UPS in the
absence of a power supply and with a full battery, simply press the button.

7. Power Saving Function

X3 EX range is equipped with a Power Saving Function. If no load connects to the UPS, it
will automatically shut down after 5 minutes to save energy during a power failure. The
Power switch must be

kept in the ‘ON’ position, otherwise the UPS will be disabled and your

equipment will not be protected during a power failure.

8. Connect Modem/Phone/Network for surge protection

Connect a single modem/phone line to a surge protected “IN” outlet on the back panel of the
UPS unit. Connect the “OUT” outlet to the computer with another phone line cable.