INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 11 10 AA 59 203 04
24
1. Important Safety Instructions:
Please strictly comply with all operating instructions in this manual strictly.
Keep this manual in a safe place and read the following instructions
carefully before installing the unit. Do not operate this unit before carefully
reading all warnings and operating instructions.
IMPORTANT!
Installing and connecting UPSs in a way that does not comply with accepted practices
releases Infosec Communication from any liability.
1-1. Transportation
Only transport the UPS system in the original package to protect against shock and
impact.
1-2. Preparation
Condensation may occur if the UPS system is moved directly from a cold to warm
environment. The UPS system must be absolutely dry before being installed. Please
allow at least two hours for the UPS system to acclimatize to the environment.
Do not install the UPS system near water or in damp environments.
Do not install the UPS system where it would be exposed to direct sunlight or near a
heater.
Do not block air ventilation holes in the UPS housing. The UPS must be
installed in a location with good ventilation or with air-conditioning. Ensure
enough space on each side for ventilation. Ideally, the room temperature
doesn’t exceed 20°C and 0-90% non-condensing humidity.
1-3. Installation
Do not connect appliances or devices which would overload the UPS system (e.g.
laser printers) to the UPS outlets.
Do not connect domestic appliances such as hair dryers to UPS outlets.
Place cables in such a way that no one can step on or trip over them.
The UPS can be operated by individuals with no previous experience.
Only connect the UPS system to an earthed shockproof power outlet which must be
easily accessible and close to the UPS system.
Only use a VDE-tested, CE-marked mains cable (e.g. the mains cable of your
computer) to connect the UPS system to the mains outlet (shockproof power outlet).
Only use VDE-tested, CE-marked power cables to connect loads to the UPS system.
When installing the equipment, you should ensure that the sum of UPS leakage
current and connected devices does not exceed 3.5mA.
1-4. Operation
Do not disconnect the mains cable on the UPS system or the mains outlet
(shockproof power outlet) during operations since this would cancel the protective
earthing of the UPS system and of all connected loads.
The UPS system has its own, internal current source (batteries). The UPS outlets or
terminal block may be electrically live even if the UPS system is not connected to the
mains outlet.
