INFOSEC UPS SYSTEM – 15 rue du Moulin – 44880 SAUTRON - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 11 16 AA 59 203 04
2
User guide
1 . S A F E T Y I N S T R U C T I O N S
IMPORTANT!
Save this manual properly and read carefully the following instructions before installing
the unit. Do not operate this unit before reading through all safety information and
operating instructions carefully. Installation and wiring must be performed in accordance
with the local electrical laws and regulations. Installing and connecting a UPS system in
a way that does not comply with accepted practices releases Infosec Communication
from any liability.
Transportation
o
Please transport the UPS system only in the original package to protect against shock
and impact.
Preparation and good disposals of the device:
o
Condensation may occur if the UPS system is moved directly from cold to warm
environment. The UPS system must be absolutely dry before being installed. Please
allow at least two hours for the UPS system to acclimate the environment.
o
Do not install the UPS system near water or in moist environments.
o
Do not install the UPS system where it would be exposed to direct sunlight or near
heater.
o
Do not block air vents in the housing of UPS. The UPS must be installed in a location
with good ventilation. Ensure enough space on each side for ventilation.
o
The mains outlet that supplies the UPS must be located near the UPS and be easily
accessible.
o
Install the UPS in a temperature and humidity-controlled room free of conductive
interference.
o
Disconnect the UPS from AC power and switch it off before cleaning with a damp
cloth (no cleaning products).
o
Do not leave any recipients containing liquid on or near the UPS.
o
Place cables in such a way that no one can step on or trip over them.
o
Prevent fluids or other foreign objects from getting inside the UPS system
Risk of electric shock:
o
The UPS unit uses potentially hazardous voltages. Do not attempt to disassemble this
equipment as it does not contain accessible components that can be repaired by
users, fuse change excepted.
o
Caution - risk of electric shock. The battery circuit is not isolated from the input
voltage. Hazardous voltages may occur between the battery terminals and the
ground. Before touching, please verify that no voltage is present!
o
The UPS system operates with hazardous voltages. Repairs may be carried out only
by qualified maintenance personnel.
o
The utility power outlet must be near the equipment and be easily accessible. To
isolate the UPS from AC input and swith it off, remove the plug from the utility power
outlet.
