INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 05 05 04 205 06
6
8. C O M P U T E R I N T E R F A C E
The interface USB at the back of the UPS may be connected to the computer. This port
enables the computer to control the UPS status. The main functions are as follows :
•
Transmission of a visual alarm in case of power failure
•
Automatic file closure prior to battery running out
•
UPS
shutdown
9 . P R O T E C T I O N F A X / M O D E M L I N E
If you wish to protect a fax or a modem, connect the telephone cable from the wall outlet to
the “IN” jack. Connect the telephone cable (provided) from the “OUT” jack to the fax or
modem.
Caution:
The telephone line current lightning feature could be rendered inoperable if
improper installed. This surge protection device is for indoor use only and never install
telephone wiring during a lightning storm.
Note:
This connection is optional. It is not necessary to use this UPS.
1 0 . B A T T E R Y
The battery is the only UPS component which is not in permanent use. It has a product life
of approximately 3 to 5 years. However, frequent major discharges or exposure to
temperatures over 20
°
C will shorten its product life. We therefore recommend that users
recharge the battery once every 3 months when the unit is not in use in order to compensate
for natural discharging. UPS back-up functioning time will depend on the load powered, the
age and the condition of the batteries.
WARNING !
Batteries should always be replaced by qualified technicians. Batteries have a very high
short circuit current :
connection errors could cause electric arcs resulting in
serious burns
.
11. T R O U B L E S H O O T I N G
Should the UPS fail to function correctly we recommend you to perform the following tests
before calling the After Sales Department.
Check list :
•
Is the main switch in the « ON » position ?
•
Is the UPS plugged into a powered mains ?
•
Does the power supply fall within specified unit values ?
•
Has the fuse gone in the mains plug ?
•
Is the UPS overloaded ?
•
Is the battery low or defective ?
