INFOSEC UPS SYSTEM
- 4, rue de la Rigotière - 44700 Orvault - France - www.infosec.fr
Hot Line :
tél : +33(0)2 40 76 15 82 -
fax :
+33 (0)2 40 94 29 51- hotline@infosec.fr - 10 05 04 205 02
-
8
-
6 INSTALLATION AND OPERATION
Upon receipt of the UPS, inspect the shipping carton for damage. If there is any obvious
damage, immediately report it to the selling dealer or the delivering carrier. If there is no
damage to the shipping carton, unpack the unit and inspect the unit for damage.
The UPS is designed for installation in a protected environment within a temperature range
from 32°F to 104°F and relative humidity of 0
∼
90% without condensation. Do not block inlets
and outlets. Install the system in a location free from excessive dust and chemical fumes.
Check the identification label to verify the UPS voltage and power rating match the available
line voltage and load requirements.
Installation:
1. Check if the main switch on the UPS front panel is in the off position and insure that the
voltage of the AC utility source corresponds to the nameplate on the UPS rear panel.
2. Plug the power cable into the grounded socket. If indicators of LINE-ON & CUT-OFF
LCD light on, it means AC power is normal, but UPS is under CUT-OFF status and it will
automatically start to charge by itself.
3. Push the main switch, then the Load Level LCD will light on for 2 seconds and CUT-OFF
LCD will light off. The UPS is ready to start working normally.
4. Connect your PCs to the UPS and then turn them on. Be sure to check the Load Level
LCD indicator and do not overload it over 100%. To simulate AC failure (simply by
disconnecting the AC power) may help to insure whether UPS is in good condition or
not. When disconnecting the UPS from AC power, the BACKUP LCD lights on and the
alarm is sounding every 3 seconds. If the CUT-OFF LCD is on, it means UPS fault or
BATTERY fault. Then you have to contact your local service center.
5. When battery approaches low level, alarm will beep every second until auto shut down.
6. The 4 conditions UPS will automatically shut down :
a. Battery low
b. Short circuit
c. Overload
d. UPS fault
