INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 06 10 AA 59 204 13
2
User guide
To ensure this product is correctly installed and used appropriately, we highly advise you to
read this user guide very carefully.
1 . I N T R O D U C T I O N
Designed to be extremely efficient and user-friendly, Z1 Zenergy Cube is the perfect UPS to
protect your computer and 2 other accessories simultaneously.
Thanks to High Frequency technology, your computer (Mac or PC) will be protected from
power disturbances, power outages and overloads. Depending on the model and on the
connected load, Z1 Zenergy Cube delivers a backup time of up to 11 minutes in the event of
an extended outage, which gives you enough time to save work in progress and properly
switch off the connected loads.
2 . M A I N C H A R A C T E R I S T I C S
A highly-reliable microprocessor control
Cold start feature if no power supply
Off-mode charging
Automatic restart during AC power recovery
Compact size.
3 . S A F E T Y I N S T R U C T I O N S – S e c u r i t y
Risk of Electric Shock:
The UPS unit uses potentially hazardous voltages. Do not attempt to disassemble
this equipment as it does not contain accessible components that can be repaired by
users.
All repairs should be performed by qualified technicians only.
The utility power outlet shall be near the equipment and easily accessible. To isolate
the UPS from AC input, remove the plug from the utility power outlet.
The mains outlet that supplies the UPS shall be located near the UPS and shall be
easily accessible.
The UPS has its own internal power supply (battery). There is a risk that output
sockets may still be live after the UPS has been disconnected from the mains power
supply.
Install the UPS in a temperature and humidity-controlled indoor area free of
conductive interference.
It should not be exposed to direct sunlight or sources of heat. Do not cover the
ventilation slots.
Disconnect the UPS from AC power before cleaning with a damp cloth (no cleaning
products).
In an emergency situation, switch the UPS to the “Off” position and disconnect the
unit from the AC power supply.
When the UPS is out of order, please refer to “
section 9: trouble shooting
” and call
the hot line.
Connected products:
Combined UPS and connected equipment leakage current should not exceed 3,5
mA.
