M2M Control CX660 Technical Manual V1.02
Advanced Automotive M2MI/IoT Gateway
Page 35 of 44
Product Identification Label with Barcode
The M2M CONTROL CX660 product identification is found on the exterior of the device and
contains a unique serial-number in readable form and as a barcode.
The first three digits in the serial number identify the device type, and for the M2M CONTROL
CX660 device, this unique code is
321
or
322.
The barcode format used:
2/5 Interleaved with Check Digit
Power consumption
The table below shows detailed information about the typical power consumption for the M2M
CONTROL CX660 device while it is running.
Power consumption: Device operating in normal mode
12V
24V
BAT
Device active
85
35
225
mA
Device active with Cellular on LTE*
110
55
300
mA
Cell idle @ -65 dBm*
Device active with GPRS on LTE*
300
150
700
mA
Cell @ -65 dBm.
Active communication.
Battery not charging*
Device active with GNSS on
100
45
280
mA
Mode 4
Device active with WLAN on
100
55
305
mA
Connected to AP, in idle
Device active with Ethernet on
100
45
310
mA
Connected to switch, in idle
Device active while charging
600
300
-
mA
Note:
Values marked with (*) is an average and should be considered as guidelines as they may
vary depending on the Cellular signal level.
Note:
Power consumption was measured from a fully charged battery.
