16
Installation of framed models
The Hanging Plates (B) should be attached to the shorter side of
the heating Panel for vertical Installation and to the longer side for a
horizontal installation. The plates are attached by using the Bolts
(C)
– 2 bolts per plate.
make sure that the corner of the panel where the cable is
attached is
not
used for mounting the plates.
and that the slots in each of the plates are mounted in
the same direction (see picture)
and that the bolts (C) are only hand tight to ensure no
damage to the frame.
Screw the two bolts (D) into the integrated nuts found in the
opposite side of the frame from where the plates are attached.
These bolts insure that the correct distance from wall to the back of
the panel is adhered too.
Measure the distance (X) between the slots and transfer this
measurement to the wall where the panel is to be installed. Use a
Spirit Level to ensure that the marks for drilling are level.
Drill each of the holes with an 8 mm drill to a depth of minimum 60
mm.
Insert the Rawlplugs (F) into the holes; make sure that both are fully
inserted. These plugs can be used universally, even for wooden walls.
Screw in the Hooked Mounting Screws (E) up to the flange making sure
that the hooked part of the screw is vertical.
Lift the Heating Panel onto the Hooked Mounting Screws and then slide
it to one side insuring that both screws are located in the dogleg part of
the slots. This insures that the heating panel cannot be easily removed
from its position.
