Basic Rules for Safety
USE
The infraNOMIC Heating Panels are designed only for use as heaters and are suitable for installation on walls
in domestic rooms which are suitable for their installation. This heater must be installed inside buildings only. Do
not store or install in outdoor areas. To use these heaters correctly it is necessary to follow the guidelines and
instructions laid down in this document.
DO NOT use the heaters in rooms that are open to the elements and/or rooms which could be subjected to the
ingress of running water.
Danger for children and persons with disabilities
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
-
Children must be supervised to ensure that they do not play with the appliance.
-
Make sure that the packing material is kept away from babies and small children as suffocation can result if
placed over their mouths or noses.
Electrical safety
-
Connect and run the heater according to the advice given on the specification plate on the rear of the heater.
Only connect the heater to a 120 V AC supply grid.
-
To provide continued protection against risk of electric shock, connect to properly grounded outlets only! The
outlet must be secured with 15 amperes.
-
Check each heater for damage before installation. Make sure that the heater itself; its plug and cable are free
of any visible signs of damage.
-
Warning: The heater must not be used if the glass panel is damaged. If damage is noticed, immediately
disconnect the panel from the power supply and contact our service department.
-
Do not pull, clamp or in any other way damage the connecting cable attached to the panel.
-
If the supply cord is damaged, it must be replaced by the manufacturer to avoid a hazard.
-
Do not attempt to carry out any repairs, changes or modifications to the heater.
-
Before any assembly or cleaning work is carried out, disconnect the panel from the electrical power.
-
Do not immerse the heating panel in water or splash water onto it!
-
When installing the panel in any form of wet room, it and its cabling should be situated well out of reach of any
person using the shower or bath. Do not install the panel near of a bath, shower or swimming pool.
-
The installation of these panels in wet rooms should always be carried out by competent electricians who are
completely aware of the specifications for installing electrical equipment in these types of room according to
their own countries laws and standards.
Product Safety Notes
-
Warning: This heater is not equipped with a device to control the room temperature. Do not use this heater in
small rooms when they are occupied by persons not capable of leaving the room on their own, unless
constant supervision is provided.
-
To avoid overheating, do not cover the heater.
-
Make sure the heater is not located immediately below a socket-outlet.
-
Do not rest anything against, or use the heating panel to dry clothes and/or stick anything onto its surface.
-
Make sure that all local objects in the immediate vicinity of the heater are a minimum of 20 inch (50,8 cm)
away from the front and sides of the panel and 4 inches (10,16 cm) away when objects are above.
-
Make sure when installing the heater that the minimum distance of 0,8 inch (2 cm) between the Wall and the
Panel is adhered too. This distance insures that enough space is available for air circulation.
3
Summary of Contents for US-64-M
Page 9: ......
