SMT-BD2
4 - X4 COMMAND CONNECTOR (Sub D 25 points male)
Pin
Function
I / O
REMARKS
1
Limit
I
Optoisolated input (I/O jumper open), positive logic (5V to 24V)
14
Limit switch -
I
Optoisolated input (I/O jumper open), positive logic (5V to 24V)
4
Current command CI
I
Optoisolated input (I/O jumper open), positive logic (5V to 24V)
7
Stop&Phasing command CV0
I
Optoisolated input (I/O jumper open), positive logic (5V to 24V)
20
Enable/Disable
I
Optoisolated input (I/O jumper open), positive logic (5V to 24V)
23,24,25 0 Volt of optoisolated input
I
Optoisolated reference (I/O jumper open)
13
RESET
I
Amplifier reset via 0 V (contact between 13 and 12)
12
0 Volt of RESET input
I
3
15
Current limitation input
0 Volt analog inputs
I
I
Current limitation 100 % to 0 % of the Maximum current value
for 0 V to 10 V (Maximum current available if not connected)
17
16
Input command CV +
Input command CV -
I
I
± 10 V speed input command with CI input inactive
(Maximum speed value for 10 V)
± 10 V current input command with CI input active
(full amplifier current rating Imax for 10 V)
10
ANout1 monitor
O
± 10 V; resolution: 12 bits; load: 10 mA
2
ANout2 monitor
O
± 10 V; resolution: 12 bits; load: 10 mA
11
0 Volt analog outputs
Programmable output signals on the digitizing oscilloscope
Channel 1 and Channel 2: current ref (IDC), current mes (ID,
IQ, IMES, I2t), speed ref (CV), speed mes (GT)
18,19
Amplifier ready
O
Relay contact: closed if amplifier OK
Pmax = 10 W with Umax = 50 V or Imax = 100 mA
Overvoltage pulses protection by bidirectional TRANSIL
5,6
Phasing OK
O
Relay contact: closed if motor phasing OK
(in motor phasing configuration without HES)
Pmax = 10 W with Umax = 50 V or Imax = 100 mA
Overvoltage pulses protection by bidirectional TRANSIL
8,9
Idyn warning
O
Relay contact: open if Idyn warning threshold is reached
Pmax = 10 W with Umax = 50 V or Imax = 100 mA
Overvoltage pulses protection by bidirectional TRANSIL
21
+ 15 V
O
47 Ohms output impedance, 50 mA max. output current
22
- 15 V
O
47 Ohms output impedance, 50 mA max. output current
21
Chapter 3 - Inputs - Outputs
