11
IM111221
RD: DEC 2011
RL: 1B
BA
InfraSave IEP-6024 Manual
6. Ensure that the field supplied bolts or lag screws fasten the mounting bracket to the wall
or ceiling of the structure with sufficient strength and integrity to support the weight of the
heater and prevent movement. The IEP 6024 weighs 13.2 lbs (6 kg). It is recommended
to fasten the mounting brackets to a structural member (wall studs, ceiling joists, etc.) or
to a field supplied support that is fastened to structural members.
7. Each end of the heater fastens to the supplied Mounting Brackets using the knob fasten-
ers (with washers) inserted through the outermost hole on the extended arm of the
Mounting Bracket. Always maintain a minimum of 4” (10 cm) between heater and the
mounting surface.
8. Rotate the heater up to 45° on the short axis by adjusting the knob fasteners.
9. Once the heater position is established, hand tighten both knob fasteners firmly to main-
tain the heater in a secure and stable position.
10. Connect each lamp circuit to a 115 - 120 Vac, 60Hz, 13 Amp copper wire circuit that is
properly grounded. Electrical connection must be performed by a qualified electrical
tradesperson. Installation must conform with the latest edition Electrical Code ANSI/
NFPA N0 70 in the U.S.A. and PART 1 CSA C22.1 in Canada.
11. Never allow an electrical cord to pass in front of the heater or to come into contact with
any hot surface of the heater
12. Read and follow all warnings, and the following section on Operation to enjoy safe opera-
tion of the heater.
FIGURE 3: MOUNTING BRACKET
FIGURE 4: END VIEW WITH
HEATER BRACKET
Align brackets to each other with
50.8 inches [129 cm] between
mount arms
OR
Fasten Brackets to Wall or Ceiling
