6
R
e
v
is
ió
n
: 0
5
R
e
f.:
M
A
N
U
_
V
B
Z
1
6
/0
2
/2
0
1
7
To maintain NSF Sanitation listing cases must have sealed to the floor.
Use NSF sealant such as silicone or equivalent cove mouldings or tiles are acceptable.
Do not block any louvered holes.
Before starting-up and placing any food inside the cabinet, firstly remove
the protective film and then clean the complete unit thoroughly. If any
adhesive remains, eliminate it with alcohol. Washing with a mild soap
and warm water solution is recommended for cleaning all the stainless
steel surfaces of your cabinet. This should be followed by cleaning with a
baking soda solution. Rinse thoroughly with clear water and dry with a
clean, soft cloth.
NOTE: Never use abrasive or harsh cleaners, concentrated detergents, solvents or chemicals
when cleaning the unit.
The supply voltage should be checked before connection to assure that proper voltage for the
cabinet wiring is available. To determine correct unit voltage, please refer to the serial data plate
located on an inner wall of the unit. Verify that this information exactly matches the electrical
characteristics at the installation location.
NOTE: Infrico requires that a sole use circuit be dedicated for the unit. Failure to do so voids
warranty.
NOTE: The unit is designed to operate with a voltage fluctuation of 5% of the voltage indicated
on the cabinet serial data plate. Burnout of the compressor due to exceeding the high or low
voltage limits will automatically void the factory warranty.
Units are provided with a U.L. approved power cord and plug which is factory installed. Infrico
uses for VBZ cases NEMA 5-15P plugs. If you do not have the right outlet have a certified electrician
install the correct power source:
5.5
Sealing Case to Floor
5.6
Initial cleaning procedure
6
ELECTRICAL INSTRUCTIONS
115 / 60 / 1 NEMA 5-15P
