Insert the Belt into the length
adjustable buckle.
(
※ Please follow the steps as
described
in the above picture.)
Holding the Belt with engraved
logo side, insert it into the top hole of
the Installing Clip, and then pull
it out again through the bottom
hole
For
Booster & Junior Car Seat
(Ages 4 and over)
Assemble the Foot Plate first and then Installing Plate after.
STEP 2. Assemble the Installing Plate
Lift the Lever of Installing Plate
Pushing the button (protrusion) of
the Installing Plate hole inside,
join the Installing Plate and the
Height Control Bar.
Place the Installing Plate on top of
the Height Control Bar and then
pull
down the Lever.
※ Install with the Hooks for Cars with ISOFIX instead of the Clips
Please refer to STEP3 on page4 for a detailed attaching method of the Hooks
STEP 3. Attaching the Belts with Installing CLIPS (Cars without ISOFIX)
Inser t the Belt to hole in the
back of the Installing Plate from
bottom to top.
Insert the Belt into the length
adjustable buckle.
(
※ Please follow the steps as
described in the above picture.)
(※ You can pull down the Height Control Lever by using slight up and down movements to match the groove and uneven surface.)
Lift the Lever of Foot Plate
STEP 1. Assemble the Foot Plate
Place the Foot Plate in the middle of the
Height Control Bar and then pull down
the Lever
Pushing the button (protrusion) of
the Foot Plate hole inside, join the
Foot Plate and the Height Control
Bar
5
1
2
