16|English
Troubleshooting
1. If your sander will not operate, check the power at the mains plug.
2. If the sander does not abrade surface, checking the sanding paper. If the sanding
paper have been worn, replace the new paper and try again. The paper must be kept in
a dry place, if it is allowed to become damp, the abrasive particles will lose their
adhesion to the backing paper and will not abrade.
3. If the sander dose not move smoothly, The sanding paper may be loose, damaged or
wrinkled. Replace and try again.
4. If a fault can not be rectified return the sander to an authorized dealer for repair.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done with a soft brush or a rag.
3. If the body of the sander needs cleaning, wipe it with a soft damp cloth. A mild
detergent can be used but nothing like alcohol, petrol or other cleaning agent.
4. Never use caustic agents to clean plastic parts.
CAUTION: water must never come into contact with this tool.
Summary of Contents for RS4508
Page 17: ...17 English RS4508 URS4508...
