TITAN GO Product Manual |
Wiring and Connections
INGENIA | 2022-07-14 08:35:14
86
7.7.5 PWM command
PWM command source sets a position, velocity or torque target from the duty cycle value of a PWM signal. PWM
command has to be interfaced with the
high-speed digital input 2 (HS_GPI2)
. Further details about this input can
page. PWM command sources with single and dual input modes can be used.
7.7.5.1 Single input mode
Single input mode is based o the use of a PWM signal whose duty cycle sets the target position, velocity or torque. A
duty cycle of 50% corresponds with a target of 0 rad, 0 rpm or 0 N·m, and higher or lower values indicate the target
in a different rotating direction. That is, a duty cycle of 0% corresponds with the maximum position, velocity or
torque in one direction, and a 100% duty corresponds to the maximum position, velocity or torque in the opposite
direction.
Examples of single input mode PWM command in differential and single ended connections are shown in the next
figures.
Summary of Contents for Titan GO
Page 19: ...TITAN GO Product Manual Product Description INGENIA 2022 07 14 08 35 14 19 ...
Page 56: ...TITAN GO Product Manual Wiring and Connections INGENIA 2022 07 14 08 35 14 56 ...
Page 89: ...TITAN GO Product Manual Wiring and Connections INGENIA 2022 07 14 08 35 14 89 ...
Page 101: ...TITAN GO Product Manual Wiring and Connections INGENIA 2022 07 14 08 35 14 101 ...
