Copyright© 2019 Ingenico
All rights reserved
11
Self/4000 Quick start
900042344 R11 000 01/1119
NOTE :
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception which can be determined by turning the equipment off and
on, the user is encouraged to try to correct interference by one or more
of the following measures :
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
The device complies with FCC radiation exposure limits set forth for general
population (uncontrolled exposure). This device must not be collocated or operating
in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
3_
Maintenance
ATTENTION
Before making any operations of maintenance in the terminal, make
sure that power supply is disconnected.
ACHTUNG
Stellen Sie vor der Durchführung von Wartungsarbeiten am Terminal
sicher, dass die Stromzufuhr abgeschaltet ist.
ATTENTION
Avant toute opération de maintenance du terminal, s’assurer que
l’alimentation électrique est déconnectée.
