SKYZER TECHNOLOGIES
PAGE 123 OF 146
11.13
MERCHANT ADMINISTRATION FUNCTIONS
The following standard merchant administration functions are available:
NOTE: When set up as a multi-merchant device, the terminal will first prompt for
the selection of the particular merchant for each of the administration
functions above.
11.13.1
Terminal Totals
This function allows the merchant to determine the total count and amount of
all accepted transactions supported by the terminal since the totals where last
reset by the merchant.
Step Terminal Display
Description
1.0
PAYMARK EFTPOS
1.EFTPOS MENU
2.TIPPING MENU
3.HOSPITALITY MENU
4.ADMIN MENU
5.SUPERVISOR MENU
Press MENU key and then scroll through using down arrow key until ADMIN MENU
is shown on the display.
Press the corresponding number key or ENTER to access ADMIN menu.
2.0
ADMIN MENU
1.TOTAL
2.INQUIRY
3.CUTOVER
Press the corresponding number key or down arrow key to select TOTAL to perform
a shift totals.
3.0
1 Merchant 1
2 Merchant 2
3 Merchant 3
Only applicable with Multi-Merchant setup.
Select the corresponding number on the terminal to select the Merchant followed by
ENTER.
4.0
PRINTING
Totals will be printed immediately.
5.0
RESET TOTALS?
ENTER=YES, CLR=NO
The user will be prompted whether the totals should be reset.
- If YES is selected, the terminal will return to idle and totals will have been reset.
(To check this, repeat steps 1-2. Totals should all appear as $0.00 on the printout.)
- If NO is selected, terminal will return to idle without resetting the totals. (To check
this, repeat steps 1-2. Totals should remain the same.)
11.13.2
Terminal Totals with Instant Tip
This function allows the merchant to determine the total count and amount of
all accepted transactions supported by the terminal since the totals where last
reset by the merchant.
INGENICO ICT2XX 2017 PAYMARK SOFTWARE OPERATING GUIDE
VERSION 1.0