Ingersoll-Rand 200CSA, Product Information

EN-2 

47083068_ed2

EN

(Dwg. TP2049)

Fan Direction

Air Cap

Lock Ring

(Dwg. TP2053)

The direction of the fan can be adjusted from horizontal to vertical be loosening the lock ring 

and turning the air cap to the proper location. Hand tighten lock ring after adjustment.

Controls

Refer to illustration 47083233 on page 2.

1. Fluid Control

The fluid control knob will adjust the atomization of the paint. Turn the knob clockwise until fully 

closed. Then while turning the knob  

counterclockwise, trigger short bursts of paint. This counterclockwise movement of the knob will 

move the pattern from fine to coarse. Adjust the knob until the desired pattern is obtained.

2. Pattern Control

The pattern control knob adjusts the size of the fan. A wide fan will result if the knob is fully 

opened by turning it counterclockwise. As the knob is turned clockwise, a smaller round pattern 

will be achieved.

3. Air Control (If Applicable)

Open the air control knob fully by turning counter clockwise. Set desired air pressure using 

regulator. Do not exceed maximum air pressure. If a lower air pressure is desired for some parts 

of the spray job, turn the air control knob clockwise as needed.

Spray Patterns

If the pattern is too coarse and the fluid control knob can not adjust it properly, try adjusting the 

air pressure or thin the paint to achieve  

desired pattern.

The spray pattern varies from round to flat with patterns in between (Refer to illustration TP2051 

on Page 2).