46812228_ed3
EN-1
EN
Product Safety Information
Intended Use:
This Air Impact Wrench is designed to remove threaded fasteners and to partially tighten and seat a threaded fastener in preparation
for manually tightening to the recommended torque using a calibrated torque wrench.
WARNING
Do not use this tool for fi nal tightening of threaded fasteners. The reduced torque in the forward direction is only intended to seat the
fastener in preparation for fi nal torquing. Always manually torque the fasteners to the recommended torque after using this tool.
For additional information refer to Torque Limited Air Wrench Product Safety Information Manual Form 45528239.
Manuals can be downloaded from www.ingersollrandproducts.com.
Power Management System
The power management system on this model can not be adjusted by the user. It is locked at the factory to always provide full power in reverse
and reduced power in forward.
Product Specifi cations
Model
Style
Drive
Impacts
per min.
Recommended
Torque Range
Impacting Sound Level dB (A)
(ISO15744)
Free Speed Sound Level dB (A)
(ISO15744)
Vibration
(ISO28927)
m/s2
Type Size
Forward
ft-lb (Nm)
Reverse
ft-lb (Nm)
† Pressure (L
p
) ‡ Power (L
w
)
† Pressure (L
p
)
‡ Power (L
w
)
Level
*K
2130XP-TL Pistol Square 1/2” 1150
35-55
(47-75) 600
(813)
99.4
110.4
84.0
95.0
10.0
1.5
† K
pA
= 3dB measurement uncertainty
‡ K
wA
= 3dB measurement uncertainty
*K = Vibration measurement uncertainty
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain condensate from valve(s) at low point(s) of piping,
air fi lter and compressor tank daily. Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off , to prevent hose whipping if a hose fails or coupling disconnects. See drawing 47132782 and table on page 2.
Maintenance frequency is shown in circular arrow and defi ned as h=hours, d=days, and m=months of actual use. Items identifi ed as:
1.
Air fi lter
7.
Coupling
2.
Regulator
8.
Safety Air Fuse
3.
Lubricator
9.
Oil
4.
Emergency shut-off valve
10.
Grease - during assembly
5.
Hose diameter
11.
Grease - through fi tting
6.
Thread size
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts be separated by material so that
they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Offi
ce or Distributor.
Summary of Contents for 2130XP-TL
Page 31: ...Notes...
Page 32: ...www ingersollrandproducts com 2011 Ingersoll Rand...
