04576005_ed14
EN-1
EN
Product Safety Information
Intended Use:
These Air Orbital Sanders are designed for smoothing and sanding paint, fiberglass, wood
and body filler.
For additional information refer to Safety Information Manual Form 04580387.
Manuals can be downloaded from www.ingersollrandproducts.com.
Product Specifications
Model(s)
Free
Speed
Pad Diameter
Sound Level dB (A)
(ISO15744)
Vibration (ISO28927)
m/s²
rpm
inch
mm † Pressure (L
p
) ‡ Power (L
w
) Level
*K
4151
12000
6
152
81.6
92.6
7.5
1.6
4151-2
12000
6
152
81.6
92.6
6.2
1.0
4151-5
12000
5
127
81.6
92.6
6.2
1.0
4152
12000
6
152
81.6
92.6
8.2
1.7
† K
pA
= 3dB measurement uncertanity
‡ K
wA
= 3dB measurement uncertanity
* K = Vibration measurement uncertainty
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16577215 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Regulator
5. Coupling
2. Emergency shut-off valve
6. Safety Air Fuse
3. Hose diameter
7. Grease - Remove sanding pad and inject
4. Thread size
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest
Ingersoll Rand
Office or Distributor.
